Control the power to any resistive load such as a heater, lamp, or electrolytic cell using any 1k to 30k potentiometer. This PWM controller runs cool while handling up to 30 amps of continuous current. A 30 Amp fuse is required for safe operation. Not for use with inductive loads such as motors.

Features:

• Use any 1k to 30k pot for control
• Automatic Soft Start ramps up to full power when first powered up to decrease stress on power supplies.
• Digital input filtering allows smooth control even with dirty pots
• Logic Controller Enable input
• High efficiency MOSFET design for cool operation
• Heavy-Duty Heatsink for reliable operation

Specifications:

• 30 Amps continuous current
• 5.5 - 20 VDC operation
• PWM Range: 0% - 100%

Connections:

• Terminal blocks for signal and power connections

Technical Documents:

Datasheet (PDF)

Application Notes:

When choosing a controller based on your input voltage requirements, please note that a fully charged 12V nominal lead-acid battery can reach 14 volts. Please check to ensure that the battery pack voltage does not ever exceed the absolute maximum rated voltage of the motor controller.

Dimensions:

2.0 x 2.7 x 1.7 inches tall.